Blog de Mr. Appz » Blog Archives

Tag Archives: Borosilicate

Anet E-10: First printings

After the previous post about the asembly of Anet E-10, today I am writeing a new post about the first printings that I have made.

Anet E-10 start up

The start up was vey simple comparing with the delta one. Hotbed leveling is very easy with this kind of printers.

I have some problems to put the filament inside the hotend, but once that it was inside the printer works perfectly.

The printer comes with Cura and Repetier software inside the included pen drive incluido, but I use Simplify 3D and I found a profile for the Anet on internet, and I have used it.

Another thing that surprised me is the fault of a firmware to update the motherboard, because the siftware is already installed on it.

Continue reading

Published by: