Blog de Mr. Appz » Blog Archives

Tag Archives: Electronics

Voron Electronics Setup (I)

What electronics has been used?

For the Voron there are two electronics options supported by the community, RAMPS plus Raspberry using Klipper as firmware, and the other one is Duet with its expansion (Duex)

I take the Duet by some reasons:

  • I knew the board
  • Integrated drivers are awesome
  • Is very easy to changes thing on the fly without need of compile a new firmware.
Continue reading Published by:

Electronics change on Anet E-10

After checking that stock electronics on Anet is not good enough for me, I have used a GT2560 motherbard to substitute the stock mainboard.

Why you want to change electronics?

As you can see on the image below, Anet board only comes with one potenciometer to control stepper drivers.

Electronics Anet

This causes, for example, that you cannot set the intensity for the extruder motor, and this is the main cause of loosing steps. Continue reading

Published by: